Roland VC-2 - Manual (Page 15)

15
Starting up VC-2
1. Before turning on the V-Synth XT’s power, consider these two questions:
* Are all peripheral devices connected correctly?
* Have the volume controls of the V-Synth XT and all connected audio devices been turned to their lowest settings?
2. Turn on the POWER switch located on the front panel of the V-Synth XT.
fig.Q-02.e
* When you turn on the power, the V-Card that was most recently started will start up.
3. After the V-Synth XT has started up, press the [V-CARD] button and touch “Vocal Designer” (VC-2) in
the screen that appears.
4. The VC-2 startup screen will appear.
* By holding down the [V-CARD] button while you turn on the power, you can take a shortcut to the above screen when the V-Synth XT
starts up.
When the VC-2 starts up, the top screen of Patch mode will appear first.
* Please be aware that in the screen shots printed in this manual, the patch names may differ from the factory settings.
ON OFF
vc2_for_XT_e1 15 ページ ２００５年３月８日 火曜日 午後４時５２分