Roland VC-2 - Manual (Page 54)

54
Effects List
27: Stereo Pitch Shifter
This effect features two pitch shifters arranged in parallel,
making it stereo compatible. It can shift the pitch of the input
signal up to one octave up or down.
28: OD/DS → Cho/Flg (Overdrive/
Distortion → Chorus/Flanger)
This effect connects either Overdrive or Distortion and either
Chorus or Flanger.
Balance DRY100:0WET–
DRY0:100WET Volume balance between the di-
rect sound (DRY) and the effect
sound (WET)
Ps Low Freq 50–4000 Hz Frequency of the low range
Ps Low Gain -15– +15 dB Gain of the low range
Ps Hi Freq 2000–20000 Hz Frequency of the high range
Ps Hi Gain -15– +15 dB Gain of the high range
Parameter Value Description
Input Mode MONO,
STEREO Selects either stereo input or mon-
aural input.
Grade 1–5 Sets the grade of the effect sound.
The higher the value is set, the
more natural-sounding can be ob-
tained; however, this increases the
delay from the source sound as
well.
Coarse Pitch
A/B -12– +12
semitone Specifies the pitch shift amount in
semitones for pitch shift A or B.
Fine Pitch A/
B -100– +100
cent Adjusts the pitch shift amount in
2-cent units (1 cent = 1/100 of a
semitone) for pitch shift A or B.
Pre Delay A/
B 0–500 ms Adjusts the delay time from the di-
rect sound until the pitch shift A
or B sound is heard.
Level A/B 0–127 Volume of the pitch shift A or B
sound.
Pan A/B L63–63R Pan of the pitch shift A or B sound.
Direct Level 0–127 Volume of the direct sound.
Feedback -98– +98 % Adjusts the proportion of the pitch
shift sound that is fed back into the
effect. Negative (-) settings will in-
vert the phase.
Low Damp
Freq 50–4000 Hz Adjusts the frequency below
which sound fed back to the effect
will be cut.
The Low Damp function damps
the low frequency band of the
pitch shift sound quicker than oth-
er bands.
Low Damp
Gain -36–0 dB Degree of Low Damp
Hi Damp
Freq 2000–20000 Hz Adjusts the frequency above
which sound fed back to the effect
will be cut.
High Damp, by attenuating the
higher frequencies first.
Hi Damp
Gain -36–0 dB Degree of High Damp
Ps Low Freq 50–4000 Hz Frequency of the low range
Ps Low Gain -15– +15 dB Gain of the low range
Ps Hi Freq 2000–20000 Hz Frequency of the high range
Ps Hi Gain -15– +15 dB Gain of the high range
Parameter Value Description
Parameter Value Description
Drive Mode OD, DS Selects whether to use overdrive
(OD) or distortion (DS).
Drive 0–127 Degree of distortion
Amp Sim Sw OFF, ON Turns the amp simulator on/off.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Distortion
(DS) Level 0–127 Volume of the overdrive or distor-
tion sound.
Mod Mode CHORUS,
FLANGER Selects whether to use chorus or
flanger.
Mod Rate 0.05–10.0 Hz,
note Adjusts the speed of modulation
for the chorus or flanger.
Mod Depth 0–127 Adjusts the depth of modulation
for the chorus or flanger.
Mod Phase 0–180 deg Sets how the chorus or flanger
sound is spread.
Mod Pre De-
lay 0–50.0 ms Adjusts the delay time from the di-
rect sound until the chorus or
flanger sound is heard.
Mod Feed-
back -98– +98 % Adjusts the proportion of the effect
sound that is fed back into the ef-
fect. Negative (-) settings will in-
vert the phase.
Xover Low-
Freq 50–4000 Hz Attenuates the effect in the range
below the specified frequency.
Xover Low
Gain -36–0 dB Specifies how greatly the low
range will be attenuated.
Xover Hi-
Freq 2000–20000 Hz Attenuates the effect in the range
above the specified frequency.
Xover Hi
Gain -36–0 dB Specifies how greatly the high
range will be attenuated.
Mod Level 0–127 Volume of the chorus or flanger
sound.
Ps Low Freq 50–4000 Hz Frequency of the low range
Ps Low Gain -15– +15 dB Gain of the low range
Ps Hi Freq 2000–20000 Hz Frequency of the high range
Ps Hi Gain -15– +15 dB Gain of the high range
vc2_for_XT_e1 54 ページ ２００５年３月８日 火曜日 午後４時５２分