Roland VC-2 - Manual (Page 30)

30
Creating/Editing Patches (Patch mode)
You can go to the top screen by touching in the
lower part of the screen.
Patches whose patch algorithm is Poly PShift do not
have this screen.
VOCODER
NATURAL VOICE
UNVOICE
* This parameter is not available if the patch algorithm is
Vocoder~ or Processor Type 2 .
Formant
* This parameter is not available if the patch algorithm is
Vocoder~ or Processor Type 2 .
TONE
* This parameter is not available if the patch algorithm is
Vocoder~ or Processor Type 2 .
Hold Dump
AutoNoteSw
* This parameter is not available if the patch algorithm is
Keyboard~ or Processor~ .
If this is on, the pitch from the mic input will be detected,
allowing you to play the VC-2 without having to play the
keyboard (i.e., without inputting note data).
In the case of a patch whose patch algorithm is Poly PShift ,
you can access the Wave screen by touching
Shifter> in the lower part of the screen.
OSC 1/OSC 2
Vocoder Screen
Parameter Value Explanation
Level 0–127 Adjusts the output level of the vocoder.
Atk 0–100 Adjusts the attack time of the vocoder.
* This parameter is not available if the patch
algorithm is Vocoder~ or Processor
Type 2 .
Rel 0–100 Specifies the time from when the vocoder
begins to operate until the volume reaches
0.
* This parameter is not available if the patch
algorithm is Vocoder~ or Processor
Type 2 .
LevelMod-
Depth -63–
+63 Adjust the output level of the vocoder us-
ing the controller assigned by
Controller
(p. 31).
Parameter Value Explanation
Level 0–127 Specifies the output level of the natural
voice (your unprocessed voice, or the orig-
inal sound of the wave for
Keyboard~
patch algorithms).
RevSend 0–127 Adjusts the reverb send level.
LevelMod-
Depth -63–
+63 Adjust the output level of the natural
voice using the controller assigned by
Controller (p. 31).
Parameter Value Explanation
Level 0–127 Specifies the amount of the detected un-
voiced consonants that will be mixed into
the output of the vocoder.
Detect 1–50 Adjusts the sensitivity at which unvoiced
consonants are detected.
Parameter Value Explanation
Type 00: FLAT–
15: STFEM2 Selects the type of formant.
Parameter Value Explanation
Tone 0–127 Adjusts the brightness of the sound.
Parameter Value Explanation
Time 0–127 Specifies the time from when the hold
pedal is pressed to fix the tonal character
from INPUT until that sound disappears.
Poly Pitch Shifter Screen
OSC
Parameter Value Explanation
Formant
Style 00: FLAT–
10: IMPROV Selects the style of vocal character
(formant).
Formant -63– +63 Adjusts the width of formant
change.
Level 0–127 Adjusts the output volume.
Pan L64–0–63R Specifies the pan of the patch. “L64”
is far left, “0” is center, and “63R” is
far right.
vc2_for_XT_e1 30 ページ ２００５年３月８日 火曜日 午後４時５２分