Roland VC-2 - Manual (Page 40)

40
Saving and Loading Projects (Disk Mode)
Never turn off the power of the V-Synth XT while
performing an operation in Disk mode. Doing so may
destroy the files.
Save the project in the work area to internal memory / PC
Card.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch .
The DISK UTILITY MENU window appears.
3. Touch .
The Disk Save Project screen appears.
4. Select the save-destination project.
If you want to save the data as a new project, touch Project>. The PROJECT Name window will appear.
Assign a name to the new project.
5. Touch .
A WARNING window appears.
If you want to cancel the procedure at this point, touch
.
6. Touch to execute the operation.
When the operation is completed, the display will briefly
indicate “COMPLETED!.”
7. Press [EXIT] to exit Disk mode.
This function loads a project on internal memory / PC Card
into the V-Synth XT’s work area.
When a project is loaded, work area will be rewritten. If
work area contains important data, you must save it
before you load other data.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch .
The DISK UTILITY MENU window appears.
3. Touch .
The Disk Load Project screen appears.
4. Select the project that you want to load.
5. Touch .
A WARNING window appears.
If you want to cancel the procedure at this point, touch
.
6. Touch to execute the operation.
When the operation is completed, the display will briefly
indicate “COMPLETED!.”
7. Press [EXIT] to exit Disk mode.
Saving a Project on Disk
(Save Project)
Loading a Project from Disk
(Load Project)
vc2_for_XT_e1 40 ページ ２００５年３月８日 火曜日 午後４時５２分