RCA 608WL - Manual (Page 159)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
157
Idle Time Limit
:
Allows you to specify after which time limit the PPP connection is released.
Otherwise stated, if no traffic passes over the PPP connection for Idle Time, the
connection is closed.
Authentication
allows you to select the default PPP authentication mechanism
when starting the PPP session. Via the drop down box, three authentication
methods can be selected for the connection:
Auto
(default):
Preferably the CHAP (Challenge Handshake Authentication Protocol) will
be used. However, if not successful, PAP (Password Authentication
Protocol) authentication is used instead. If in turn PAP fails, the
connection will NOT be authenticated.
CHAP
:
CHAP authentication is forced. If not successful, the connection will NOT
be authenticated.
PAP
:
PAP authentication is forced. If not successful, the connection will NOT
be authenticated.
Local IP
and Remote IP:
During PPP session setup IP addresses are negotiated. Typically at the client
side, these fields are left empty. This forces the client to ask the server for
addresses. To setup the SpeedTouch™ as PPP server, you are able to supply
suitable values (according your network configuration).
Primary DNS
and Secondary DNS:
During PPP session setup the BRAS will normally provide the DNS server IP
addresses. Typically at the client side, these fields should therefore be left
empty.
In cases where the DNS server IP addresses are not provided by the BRAS, or
to setup the SpeedTouch™ as PPP server, you are able to supply suitable values
(according your network configuration).
Statistics For a running PPP session the fourth tab allows you to overview following connection
statistics:
IP address
:
local IP address assigned by the server.
Bytes received :
Number of bytes received on this PPP connection.
Bytes dropped
:
Number of bytes failed to transmit.
Bytes sent
:
Number of bytes transmitted over this PPP connection.