RCA 608WL - Manual (Page 143)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
141
Adding an interface
related expression
To add a new interface related expression:
1 Click New.
2 In the Interface Expressions Properties table:
Type a Name for the expression.
Select the Interface group the expression should relate to. For negative
logic, select Not.
Select the interface the expression should relate to. An interface is the
connection between the SpeedTouch™ and one of his attached networks.
Possible interfaces you can select out of are:
Physical interfaces
ATM interfaces
Ethernet interfaces
IP interfaces
PPP interfaces
For negative logic, select Not.
3 Click Apply to add the expression to the table.
IP The IP section bundles all expressions that express a relation based on IP addresses.
The Expressions table provides following information per expression:
The Name of the expression
A Summary of the expression’s configuration.
For more detailed information you can expand the expression (click ).
Adding an IP related
expression
To add a new IP related expression:
1 Click New.
2 In the IP Expressions Properties table:
Type a Name for the expression.
Type an IP address or an IP address range. For negative logic, select Not.
3 Click Apply to add the expression to the table.
Service The Service section bundles all expressions that express a relation based on services.
The Expressions table provides following information per expression:
The Name of the expression
A Summary of the expression’s configuration.
For more detailed information you can expand the expression (click ).
You can define a valid IP address range by:
Typing a subnet, e.g. 10.0.0.0/8
Typing a IP address subset range, e.g. 10.[1-31].[9-11].[1-5]
Using wild cards, e.g. 192.5.*.*