Roland AT90S - Manual (Page 51)

49
Chapter 1 Selecting and Playing Sounds
1.
The volume levels of each part are adjusted using the
corresponding [▲] and [▼] buttons.
Pressing the upper button ([▲] button) will increase the volume.
Pressing the lower button ([▼] button) will decrease the volume.
The volume can be set to any value from 0 to 12.
When the volume value shown in the display is 0, that part will produce no
sound.
You can also press the [▲] button and [▼] button of the part whose volume
you wish to adjust, so that the “Part Balance Monitor screen” is displayed
for several seconds, allowing you to check the volume balance.
fig.01-27
You can check the volume by viewing the Level Balance indicators of each
part on AT-90S/80S.
fig.01-27-2
The Part Balance Monitor
screen is displayed for
several seconds and then
closes automatically.
If you touch , the
screen continues to be
displayed until you touch
again.
Sax Violin Trumpet
Flute
Oboe
Clarinet Level
Alternate To Lower
Solo
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence