Roland AT90S - Manual (Page 193)

191
Error Message
Error Message Meanings
Copy Protected.
Can’t Save
To protect the copyright, this music file cannot be saved as SMF format.
When you want to save as Atelier format, you can save only original disk.
Can’t Save
This Song. You can only play the music data. It cannot be saved on a floppy disk or internal memory.
Write Protected
Disk The protect tab on the floppy disk is set to the Protect position.
Change it to the Write position and repeat the procedure.
Master Disk
This floppy disk cannot store the format or save any data. Insert a different disk and repeat
the procedure.
Read Only Song.
Can’t Save A new song cannot be saved onto this floppy disk.
No Disk
No floppy disk is connected to the disk drive. Insert the disk correctly, and repeat the pro-
cedure.
Disk Full
There is not sufficient space left on the floppy disk for the data to be saved. Save the data
onto a different floppy disk or delete music data on the disk.
Unknown Disk
The floppy disk inserted into the disk drive cannot be read.
Please format the floppy disk.
Disk Ejected
The floppy disk was removed from the disk drive while loading or writing was in progress.
Insert the floppy disk and repeat the procedure.
Damaged Disk
This floppy disk is damaged and cannot be used. Insert a different disk and repeat the pro-
cedure.
Can’t Read This song cannnot be read.
Can’t Play
It cannot be read the floppy disk quickly enough. Press the [Reset] button, then press the
[Play/Stop] button to play the song.
Memory Full
The Rhythm data is excessively large, and cannot be loaded.
The performance data is excessively large, and cannot be loaded.
Since the internal memory is full, recording or editing is not possible.
MIDI Buffer Full
The AT-90S/80S/60S cannot deal with the excessive MIDI data sent from the external
MIDI device. Reduce the amount of MIDI data sent to the AT-90S/80S/60S.
Communication
Error A MIDI cable or computer cable has been disconnected. Connect it properly and sucurely.
Computer I/F
Error
The Computer Switch is set to a wrong position or the computer is set wrongly. Switch off
the AT-90S/80S/60S then set the Computer Switch to the correct position and set the com-
puter correctly. After that, switch on the AT-90S/80S/60S again.
Memory Error There is something wrong with the system. Repeat the procedure from the beginning.