Ricoh Aficio 340 - Manual (Page 273)

ACCEPTABLE TYPES OF ORIGINALS
17
1
• When you set an original on the exposure glass, an original narrower than
about 9.25” is scanned as LT/LG size wide. An original wider than 10.83”
is scanned as DLT size wide. Normally, lengths up to a maximum of 17”
can be scanned (this figure varies slightly depending on the type of origi-
nal). If you select Irregular Scan Area, lengths up to 17” are possible.
- - - -Maximum Scan Area
Memory Transmission/Immediate Transmission
• From the Document Feeder (ADF): 297
×
432 mm (W
×
L)
• From the exposure glass : 297
×
432 mm (W
×
L)
If the Machine Cannot Detect the Size of Your Original
If the machine cannot detect the original size, the following display is shown:
If this happens, carry out the following steps.
A
Remove the original and replace it on the exposure glass. Press the
{{{{
Start
}}}}
key to scan the original again. If the machine still cannot detect the original
size, the following display is shown:
B
Press the
< < < < and > > > > keys to switch the scan size and press the {{{{
Start
}}}} key
again.
Length
width
∼
"9.80 "9.80
∼
"10.79 "10.79
∼
"12.44 "12.44
∼
∼
"9.57 not detected LT L LT L LG L
"10.55
∼
LT
K
DLT
L
DLT
L
DLT
L