Ricoh 70E - Manual (Page 10)

SAFETY SUMMARY (Continued)
Safety 3
II L 00
• Observe the speed limit of 300 mm/sec. (1.08 km/hr) when moving device. Do not
move device on unleveled floor. Do not tilt device 15 ° or more.
(Section 2.1,Page 2-1)
(Section 2.2,Page 2-6)
(Section 2.3,Page 2-9)
(Section 2.4,Page 2-11)
• Choose the location to place device where the slope is less than 15 °. (Only left and right
direction from view of operator’s side.)
(Section 2.1,Page 2-1)
(Section 2.2,Page 2-6)
(Section 2.3,Page 2-9)
• Choose the location to place device where there is no condensation.
(Section 2.1,Page 2-1)
(Section 2.2,Page 2-6)
(Section 2.3,Page 2-9)
(Section 2.4,Page 2-11)
• Choose the location to place device where the slope is less than 15 °.
(Section 2.4,Page 2-11)
• The voltage is constantly in unless the machine is unplugged or Breaker Switch is turned off.
(Section 4.1,Page 4-3)
• Unplug the Power Supply Cable prior to connecting the power supply source.
(Section 4.1,Page 4-3)
• Be careful not to have other personnel plug in the power cable while performing the connecting.
(Section 4.1,Page 4-3)
(Section 4.1,Page 4-4)