Nortel Networks M3310 - Manual (Page 98)

98 Digital Telephone IP Adapter Installation and Administration Guide
Configuring the IP Adapter unit using the telephone menu Standard 2.1
manually enter
static IP
information for
this Digital
Telephone IP
Adapter
unit,
1 Press 2.
2 Press the Hold key.
Result: The telephone display prompts you for the
Digital Telephone IP Adapter unit’s new, permanent
IP address. The telephone display also shows the
current setting, similar to the following:
Enter IP Address
0.0.0.0
3 Press the digits of the Digital Telephone IP Adapter
unit ’s permanent IP address. Use the * key for the IP
address delimiter. (Refer to the table on page 85.)
4 Press the Hold key.
Result: The telephone display prompts you for the
Digital Telephone IP Adapter unit’s new, permanent
IP subnet mask. The telephone display also shows
the current setting, similar to the following:
Enter IP Subnet Mask
255.0.0.0
5 Press the digits of the Digital Telephone IP Adapter
unit ’s permanent IP subnet mask.
6 Press the Hold key.
Result: The telephone display asks if you want to
modify the Digital Telephone IP Adapter unit’s IP
gateway, similar to the following:
Modify IP Gateway?
[1-Yes 2-No]
Note: Assigning static IP addressing to a Digital Telephone IP Adapter
unit allows you to use the address information to identify the unit on the IP
network. This makes the unit more accessible for online administration
and maintenance.
IF you want to THEN do the following: