Nortel Networks M3310 - Manual (Page 97)

Digital Telephone IP Adapter Installation and Administration Guide 97
January 2005 Configuring the IP Adapter unit using the telephone menu
12 The telephone display asks if you want to modify the IP parameters, similar
to the following:
Modify IP Parameters?
[1-Yes 2-No]
IF you want to THEN do the following:
retain the current
IP parameters
configured for this
Digital Telephone
IP Adapter
unit,
1 Press 2.
2 Press the Hold key.
3 Proceed to step 13 on page 101.
modify the IP
parameters
configured for this
Digital Telephone
IP Adapter
unit,
1 Press 1.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable Dynamic Host Configuration Protocol
(DHCP), similar to the following:
Enable DHCP?
[1-Yes 2-No]
allow a DHCP
server to
dynamically
assign an IP
address to this
Digital Telephone
IP Adapter
unit
each time
someone logs on
with this unit,
1 Press 1.
2 Press the Hold key.
3 Proceed to “Enable DiffServ? [1-Yes 2-No]” on
page 99.
Note: Refer to the Reach Line Card Installation and
Administration Guide (NTP 555-8421-210) for more
information on DiffServ CodePoint and 802.1Q
Mapping.