Powering up the digital telephone internal ip, Adapter circuit card – Nortel Networks M3310 User Manual
Page 75
Digital Telephone IP Adapter Installation and Administration Guide
75
January 2005
Installing the Digital Telephone IP Adapter unit
Complete the following procedure:
1
If you want to route calls over the IP network or administer the Digital
Telephone Internal IP Adapter circuit card with Configuration Manager,
connect the circuit card to the Ethernet network by making the following
connections:
a. Connect one end of the RJ-45 Ethernet cable to the ETHERNET
connector on the Digital Telephone Internal IP Adapter circuit card.
b. Connect the other end to either an Ethernet hub or network router.
2
Connect the Digital Telephone Internal IP Adapter circuit card to the power
source as follows:
a. Connect the appropriate cord on the power transformer to the power
connector on the Digital Telephone Internal IP Adapter circuit card.
b. Plug the power connector into an uninterruptible power supply (UPS) or
wall outlet.
Powering up the Digital Telephone Internal IP Adapter circuit card
As soon as you connect the Digital Telephone Internal IP Adapter circuit card to
the power source, the circuit card begins to power up.
During power-up, the Digital Telephone Internal IP Adapter circuit card
performs a self-test. The power LED flashes three times to verify all critical
functionality.
If the Digital Telephone Internal IP Adapter circuit card completes a successful
self-test, the telephone display shows one of the following messages:
!
A time and date, if connected to a PBX.
!
HOSTLESS MODE
, if not connected to a PBX.
Note: The ETHERNET TX and RX LEDs flash only in response to transmit and
receive activity.