Nortel Networks 380-24F - Manual (Page 69)

Chapter 4 Configuring the switch 69
Using Web-based Management for the BayStack 380-24F Gigabit Switch
Deleting an SNMPv3 target parameter configuration
To delete an SNMPv3 target parameter configuration:
1 From the main menu, choose Configuration > SNMPv3 > Target Address.
The Target Address page opens ( Figure 21 on page 65 ).
2 In the Target Parameter Table, click the Delete icon for the entry you want to
delete.
A message opens prompting you to confirm your request.
3 Do one of the following:
• Click Yes to delete the target parameter configuration.
• Click Cancel to return to the table without making changes.
Configuring an SNMP trap receiver
You can configure the IP address and community string for a new SNMP trap
receiver, view a table of existing SNMP trap receiver configurations, or delete an
existing SNMP trap receiver configuration(s).
Creating an SNMP trap receiver configuration
To create an SNMP trap receiver configuration:
1 From the main menu, choose Configuration > SNMP Trap Receiver.
The SNMP Trap Receiver page opens (Figure 23) .
Note: The SNMP Trap Receiver Table is an alternative to using the
SNMPv3 Target Table and SNMPv3 Parameter Table. However, only
SNMPv1 traps are configurable using this table.