Pitney Bowes ADDRESSRIGHT DA400 - Manual (Page 27)

3-2
Basics
Setting up a print job means adjusting the printer to ac-
com mo date the width, height, thickness and weight of your
ma te ri al.
There are two things that determine how reliably your
printer feeds: the setup adjustments and the quality of your
material. A good setup minimizes misfeeds and jams. And
your printer will perform at its best when you run material
that falls within our published specifications. See Appendix
B for complete material specifications.
1. Setting the Separator Gap
Whenever you switch from
one material type to anoth-
er, you need to set the gap
between the separators
and the feed roller before
printing begins.
There are three positions of
the "H" Blocks:
• Lever fully down
- adjusted to media
thickness (ready to operate).
• Lever midpoint - not adjusted to any media (free-floating
on media, not set up to operate).
• Lever fully up - locked in the up position, not adjusted to
any media thickness.
Setting the Proper Feed Gap
A. Unlatch and lift the lock
Levers to their highest
position.
This raises the H-Blocks.
Setting Up A
Job
H Block
Separators
SV61186ABook.indb 3-2 3/29/2004, 1:44:51 PM