Pitney Bowes ADDRESSRIGHT DA400 - Manual (Page 23)

2-6
Setup
Assembling
the Printer
(continued) 4. Connecting the Parallel Cable or USB Cable
Use the parallel cable to connect the printer to a standard
Centronics parallel port on your computer, or if your com-
puter has USB ports, you can use a USB cable.
The Address Printer ports are located on the rear of the
printer near the power switch.
Parallel Cable
A. Align the male end of the parallel cable to the port on
the printer. Push the cable connector completely in.
B. Secure the cable in place by snapping the two wire
clips located on each side of the parallel connector into
the tabs on the cable.
C. Align the other end of the cable to the connector on the
computer and push into the port.
D. Secure the cable in place by screwing the thumb
screws on the cable connector into the connector on
the computer.
USB Cable
A. Align the squarer end of the USB cable to the USB port
on the printer. Push the cable connector completely in.
B. Align the flatter, rectangular end of the USB cable to
the USB port on the computer or USB hub. Push the
cable connector in completely.
Parallel Port
USB Port
SV61186ABook.indb 2-6 3/29/2004, 1:44:49 PM