Polycom VSX Series - Manual (Page 220)

Administrator’s Guide for the VSX Series
Appendix - 16
PathNavigator Error Codes
The following table lists PathNavigator error codes.
Code Cause Description
150 No Network
Resources The network does not have enough resources to
complete your call. Try calling at a lower rate, or
try the call again later.
151 No Network
Resources The network does not have enough resources to
complete your call. Try calling at a lower rate, or
try the call again later.
152 Gatekeeper
Problems Your call could not be completed because of an
internal error in the gatekeeper or endpoint.
Contact the gatekeeper or endpoint vendor for
assistance.
153 Incorrect Address Your call could not be completed because of an
internal error in the gatekeeper or endpoint.
Contact the gatekeeper or endpoint vendor for
assistance.
154 Gatekeeper
Problems Your call could not be completed because of an
internal error in the gatekeeper or endpoint.
Contact the gatekeeper or endpoint vendor for
assistance.
155 Gatekeeper
Problems Your call could not be completed because of an
internal error in the gatekeeper or endpoint.
Contact the gatekeeper or endpoint vendor for
assistance.
156 Gatekeeper
Problems Your call was rejected by the gatekeeper. Contact
your Network Administrator for assistance.
157 Gatekeeper
Problems Your call could not be completed because of an
internal error in the gatekeeper or endpoint.
Contact the gatekeeper or endpoint vendor for
assistance.
158 Gatekeeper
Problems Your call could not be completed due to
gatekeeper problems. Try the call again later.
159 System Not
Registered with
Gatekeeper Your system must be registered with the
gatekeeper before you can place a call. Contact
your Network Administrator for assistance.
160 Far Site Not
Registered with
Gatekeeper The system you are trying to call is not registered
with the gatekeeper.
164 Far Site Busy The system you called is busy. Try the call again
later.