Promise Technology Network Device EX8654 User Manual
Page 304

SuperTrak EX Series User Manual
290
10. Replace the screw holding the SuperTrak EX Controller card to the system
case.
11. Attach the SAS multi-lane cables to the SuperTrak EX Controller card.
12. Replace the cover of your system.
13. Power-up the system and launch WebPAM PRO.
See “Logging into WebPAM PRO” on page 107.
After installation and power-up, a new battery takes several hours to charge.
From that time, it should show Fully Charged. See “Viewing Battery Information”
on page 142.
The BBU module is covered by a one-year warranty. See “Limited Warranty” on
page 276.
This manual is related to the following products: