Examples – Promise Technology Network Device EX8654 User Manual
Page 222

SuperTrak EX Series User Manual
208
temppollint=Drive temperature polling interval in seconds. If value is 0,
polling is disabled. For subsystems with dual controllers.
15..255
mediumerrorthreshold=
Medium error threshold. If the threshold is reached, the
physical drive is marked as dead. The default value is 0,
indicating that physical drive is not marked as dead for
medium errors. For subsystems with dual controllers.
0..4294967294
The following settings are only for SATA drives:
dmamode=
For SATA drive only. Attempt to negotiate at the specified
DMA transfer mode. If a DMA transer mode cannot be
negotiate, the next slower mode is attempted until a
mode can be negotiated (udma5, udma4....udma0,
mdma 2.....mdma0).
udma0
Ultra DMA Mode 0
udma1
Ultra DMA Mode 1
udma2
Ultra DMA Mode 2
udma3
Ultra DMA Mode 3
udma4
Ultra DMA Mode 4
udma5
Ultra DMA Mode 5
mdma0
Multi DMA Mode 0
mdma1
Multi DMA Mode 1
mdma2
Multi DMA Mode 2
speed=
Set the speed of physical drive(s).
1.5gb
1.5 GB/s
3gb
3 GB/s
auto
Automatic
The following settings are only for SAS drives:
readcache=
Applied to SAS drive only. Enables or disables read
cache on the physical drive(s).
enable
disable
-v
Verbose mode. Used with -a list.
Examples
phydrv
phydrv -v