Paradyne Hotwire Routers - Manual (Page 89)

Traps & MIBs
C-17 6371-A2-GB20-10 August 2000
Interface Configuration MIB
The Paradyne proprietary Interface Configuration group, pdn_inet.mib, is
supported. Refer to Table C-11 for additional details.
Table C-11. Interface Configuration Group Objects Table
Object Description Setting/Contents
pdnInetIpAddress
(pdnInetIpAddressTableEntry 1) Identifies the interface IP
address. H Interface IP address or
H 0.0.0.0 – Unnumbered interface
pdnInetIpSubnetMask
(pdnInetIpAddressTableEntry 2) Identifies the interface subnet
mask. H P – Passed selftest
H F – Failed selftest
pdnInetIpAddressType
(pdnInetIpAddressTableEntry 3) Use to view the address type
for an interface. Supported as
read-only. H primary
H secondary
pdnInetIpRowStatus
(pdnInetIpAddressTableEntry 4) Use to add/delete/modify rows
in this table. When used to add a new interface entry, the
objects specifying the table entry must be
included in the same Set PDU.
ARP MIB
The objects from the proxy ARP MIB group, pdn_Arp.mib, are:
H pdnNetToMediaClearAllArp (pdnNetToMediaConfig 2) – Setting this object to
clear removes all entries from the ARP table and is equivalent to the
command:
arp purge
H
pdnNetToMediaProxyArpTable
NAT MIB
The objects in the Network Address Translation MIB group, pdn_NAT.mib, are
fully supported. The groups are:
H
Network Address Translation Group – Facilitates the creation and
configuration of NAT entries. The DSL router accepts any valid public IP
address (up to 256 addresses) and subnet mask for basic NAT operation.
H
NAPT Mapping Group – Facilitates the creation and configuration of NAPT
mappings. The DSL router accepts any single, public IP address for NAPT
operation. The subnet mask 255.255.255.255 is used when the NAPT
IP address configuration information is viewed.
H
NAT Basic Mapping Group – Facilitates the creation and configuration of
Basic NAT mappings.