Paradyne Hotwire Routers - Manual (Page 27)

Configuring the DSL Router
3-7 6371-A2-GB20-10 August 2000
IP Options Processing
The NAT and NAPT functions handle and process the IP datagrams with options
set as described below. No command is available to set IP options.
The DSL Router does not process (and drops) any IP datagrams with the
following IP options:
H
Loose source and record route (type 131)
H Strict source and record route (type 133)
H
Security (type 130)
H Stream ID (type 136)
The DSL Router does process IP datagrams with the following IP options, but
does not provide its IP address or timestamp information in the response
message:
H Record route (type 7)
H
Timestamp (type 68)
Applications Supported by NAT
The DSL routers support the following applications and protocols:
H
FTP
H HTTP
H
NetMeeting
H
Ping
H
RealPlayer
H
Telnet
H TFTP
Dynamic Host Configuration Protocol (DHCP) Server
The DSL router provides a DHCP Server feature as specified in RFC 2131,
Dynamic Host Configuration Protocol, and RFC 2132, DHCP Option and BOOTP
Vendor Extensions. DHCP is the protocol used for automatic IP address
assignment.
DHCP setup considerations:
H The range of IP addresses to be used by the DHCP server must be
configured. The maximum number of clients is 256.
H
The DHCP server must be enabled.