Paradyne Hotwire Routers - Manual (Page 19)

Accessing the DSL Router
2-5 6371-A2-GB20-10 August 2000
Using the List Command
The list command displays a sequence of commands, in the form of ASCII
strings, that would have the effect of setting all configuration settings to the
current values. (The two passwords are not output.)
To determine the commands available, enter the Administrator configuration
mode and enter either:
H
list
Displays the output in on-screen page mode. In on-screen page mode, the
user interface displays 23 lines of information. When the 24th line is reached,
More... is displayed. Pressing any key will display the next page.
H
list config
Displays the output in scroll mode as a text file. Scroll mode captures and
displays all command strings in a text file for use with a terminal emulation
program. Refer to Appendix D,
DSL Router Terminal Emulation .
Changing the System Identity
"
Procedure
To change the System Identity from the factory default of CUSTOMER>:
1. Login and enter the ADMIN-configuration mode.
2. At the CUSTOMER-CONFIG#> prompt, type the new System identity
(no spaces allowed), press Enter, type save , and press Enter.
system identity new system identity
For example:
system identity PARADYNE and press Enter
save and press Enter
3. In this example, after saving the entry and ending the configuration mode, the
System identity will display:
PARADYNE #>
The System identity is the same as the MIB entry of sysName. The
sysContact and SysLocation MIB entries are not displayed.
Exiting from the System
You can manually log out of the system, or let the system automatically log you
out. The DSL router will log you out immediately if you disconnect the Console
cable. Any unsaved configuration input will be lost.