Paradyne Hotwire Routers - Manual (Page 57)

Command Line Interface
A-7 6371-A2-GB20-10 August 2000
ARP Table
arp timeout incomplete [ time ]
Specifies the ARP table timeout value in seconds for incomplete ARP table entries.
Default = 5 seconds.
Minimum access level: Administrator/Config
arp timeout complete [ time ]
Specifies the ARP table timeout value in minutes for complete ARP table entries.
Default = 20 minutes.
Minimum access level: Administrator/Config
arp { create | delete } ip-address mac-address
Creates or deletes a single, static ARP table entry. Static ARP entries created with this
command are retained across resets/power cycles.
Minimum access level: Administrator/Config
create – Create an ARP table entry.
delete – Delete an ARP table entry.
ip-address – The IP address of the ARP entry to be created or deleted.
mac-address – MAC address (valid for create command).
Examples: arp create 132.53.4.2 00:10:4b:97:6c:44
arp delete 132.53.4.2
arp purge
Deletes ALL static and dynamic ARP table entries.
Minimum access level: Administrator/Config
Proxy ARP
proxy arp { eth1 | dsl1 } [ enable | disable ]
Enables or disables proxy ARP for the specified interface.
Minimum access level: Administrator/Config
eth1 – The Ethernet interface.
dsl1 – The DSL interface.
enable – Enable Proxy ARP. Default = Enable.
disable – Disable Proxy ARP.
NOTE: Proxy ARP and NAPT cannot be enabled at the same time. When Basic
NAT is enabled, Proxy ARP is allowed on the dsl1 interface.
Example: proxy arp dsl1 disable