Paradyne Hotwire Routers - Manual (Page 16)

Accessing the DSL Router
2-2 6371-A2-GB20-10 August 2000
Changing Access Session Levels
H
You can change the Administrator access level by entering:
admin enable
This command provides Administrator access level privileges. The DSL
router will respond with a prompt to enter the password for Administrator
access.
H
You can end the Administrator access level by entering:
admin disable
This command results in ending the Administrator access level session. No
password is needed.
Entering exit has the same results. Refer to Exiting from the System on
page 2-5 for further details on ending a session.
The Operator and Administrator have the same Login ID with different passwords
for their access level. To determine the level of access for a session, refer to
Determining the Current Access Level on page 2-4.
Local Console Access
The DSL router ships with the local console enabled. After login, the local console
can be disabled with the command
console disable . After saving this change
and ending the session, there is no local access through the console port. Any
access must be through a Telnet session or the NMS.
NOTE:
Entering console disable results in NO local access to the DSL router.
If you attempt to log in, you will receive an error message.
To determine via a Telnet session if a console is enabled, enter:
show console
The display returned for the show console command will be:
H
console enabled – Command line management at the console is
available, or
H
console disabled – No command line management is available at the
console.
For steps to set up the new user’s login, refer to Setting Up the New User’s Login
on page 2-3.