Paradyne Hotwire Routers - Manual (Page 31)

4-1 6371-A2-GB20-10 August 2000
DSL Router Configuration
Examples
4
Configuration Examples
The Hotwire DSL Router configuration examples include only a few of the
possible scenarios. This chapter covers some of the common configurations.
The command syntax will vary based on your network setup.
Configuration commands require the access level of Administrator-Config and
changes need to be saved while in configuration mode to take effect. Refer to
Chapter 2,
Accessing the DSL Router .
The Hotwire DSL Router configuration examples include:
H Basic
H
Basic NAT
H NAPT
H
Unnumbered DSL Interface with Proxy ARP
H DHCP Relay with Proxy ARP
H
DHCP Server with Basic NAT
H Downstream Router
Refer to Appendix A, Command Line Interface , for specific commands and
syntax.
Refer to Appendix B, Configuration Defaults & Command Line Shortcuts , for
specific command default settings and abbreviated command line syntax.
NOTES:
— The examples in this chapter are provided to illustrate some of the
features of the Hotwire DSL Routers. Not all possible feature
configurations are covered in the examples.
— The IP addresses used in the examples are for illustrative purposes only.
These addresses are not intended for use when configuring your local
network.