Paradyne Hotwire Routers - Manual (Page 40)

Monitoring the DSL Router
5-2 6371-A2-GB20-10 August 2000
Status of Interfaces
From the Command Line Interface, the current status of the Ethernet (eth1)
Interface and the DSL (dsl1) Interface can be obtained with one command:
show interface
The information displayed for Ethernet and DSL Interfaces is presented below.
show interface { eth1 | dsl1 }
Use to request status statistics for the named interface, eth1 or dsl1.
Minimum access level: Operator
eth1 – Ethernet interface
dsl1 – DSL interface
eth1 status – Fields included in the display of Ethernet status: eth1
– Ethernet Link: { up | down }
This is the same status as reflected by the Ethernet LED.
– MAC address: xx:xx:xx:xx:xx:xx
– proxy ARP eth1 { enabled | disabled }
– ifn eth1:1 – ip-addr x.x.x.x mask x.x.x.x *
– ifn eth1:2 – ip-addr x.x.x.x mask x.x.x.x
– ifn eth1:3 – ip-addr x.x.x.x mask x.x.x.x
– ifn eth1:4 – ip-addr x.x.x.x mask x.x.x.x
dsl1 status – Fields included in the display of DSL status: dsl1
– DSL Link: { up | down }
This is the same status as reflected by the DSL LED.
– MAC address: xx:xx:xx:xx:xx:xx
– proxy ARP dsl1 { enabled | disabled }
– ifn dsl1:1 – ip-addr x.x.x.x mask x.x.x.x *
– ifn dsl1:2 – ip-addr x.x.x.x mask x.x.x.x
– ifn dsl1:3 – ip-addr x.x.x.x mask x.x.x.x
– ifn dsl1:4 – ip-addr x.x.x.x mask x.x.x.x
* The Primary designation of a numbered interface marks that interface as the one
whose IP address is used as a Router ID. If no interface is defined as Primary, the last
numbered interface created becomes the Primary IP Address.