Paradyne Hotwire Routers - Manual (Page 86)

Traps & MIBs
C-14 6371-A2-GB20-10 August 2000
Table C-8. Application Test Group Objects (3 of 3)
Object Setting/Contents Description
applTraceroutePacketSize
(traceroute 4) Specifies TraceRoute packet
size. Range + 28 bytes of header
information. H 28 — 15028 – Range.
H 64 – Default.
applTracerouteTimeOut
(traceroute 5) Timeout value in seconds
between echo request attempts. H 10 – Default.
applTracerouteMaxHops
(traceroute 6) Maximum number of hops to be
tested. H 8 – Default.
applTracerouteDomain
(traceroute 7) Specifies the destination IP
address’s service domain. H mgmt(2) – Management Domain.
H service(3) – Service Domain. Default.
applTracerouteIfIndex
(traceroute 8) Specifies the route for the
TraceRoute test. If the target interface is not specified, the
default will display the calculated ifIndex.
applTracerouteTestOwner
(traceroute 9) Identifies who started the test. 1 – 40 characters.
applTracerouteTestId
(applTracerouteResultsEntry 1) Contains the results of a
TraceRoute test. Supports only one test per device.
applTracerouteHopCount
(applTracerouteResultsEntry 2) Number of hops to reach the
gateway. —
applTracerouteResultsIpAddr
(applTracerouteResultsEntry 3) IP address of the gateway. —
applTracerouteResultsHopCount
(applTracerouteResultsEntry 4) Number of hops to reach the
gateway. —
applTracerouteResultsPacketSize
(applTracerouteResultsEntry 5) Specifies the data size of the
packets (in bytes) sent during the
TraceRoute test. —
applTracerouteResultsProbe1
(appTracerouteResultsEntry 6) Displays roundtrip time in 100 ms
intervals of the first probe sent to
the gateway. H 0 – Probe has timed out.
applTracerouteResultsProbe2
(applTracerouteResultsEntry 7) Displays roundtrip time in 100 ms
intervals of the second probe
sent to the gateway. H 0 – Probe has timed out.
applTracerouteResultsProbe3
(applTracerouteResultsEntry 8) Displays roundtrip time in 100 ms
intervals of the third probe sent to
the gateway. H 0 – Probe has timed out.
diagTestTrapEnable
(configure 1) Use to enable or disable
diagApplTestStart and
diagApplTestStop traps. Bit Sum.
H 1 – Test Start.
H 2 – Test Over.