Configuration mib, C-16, Pdn_config.mib) – Paradyne Hotwire Routers User Manual
Page 88
Traps & MIBs
C-16
6371-A2-GB20-10
August 2000
Configuration MIB
The supported groups used with the DSL Configuration MIB, pdn_Config.mib,
are:
H
Device Configuration Copy Group
H
Trap Configuration Group
H
Paradyne Device Configuration Time Group
H
Traps
Table C-10.
Device Configuration Copy Group Objects Table
Object
Description
Setting/Contents
devConfigAreaCopy
(devConfigArea1)
Use to configure the current configuration to the
factory defaults settings.
NOTE:
ALL current configuration input is
purged when the DSL router is
resets as a result of this command.
Data purged includes:
– Interface IP addresses
– IP route table entries
– ARP cache entries
– NAT entries
– DHCP server entries
H
noOp (1) – always reads as this
value and represents:
factory1-to-active(8)
devConfigTrapEnable
(devConfigTrap1)
This object determines which trap types are
sent, represented by a bit map as a sum.
Allows multiple trap types to be enabled or
disabled simultaneously.
Bit positions:
H
1 – warmStart trap
H
2 – authenticationFailure trap
H
4 – enterpriseSpecific traps
H
8 – LinkUp trap
H
16 – LinkDown trap
devConfigTimeOfDay
(devConfigTime 1)
Displays the current time.
—
cCN(7)
Signifies a configuration change or a software
upgrade.
H
7 – Warning trap
cCNTrapEnable
(router 28)
Use to enable or disable the configuration
change trap.
H
1 – Disable trap
H
2 – Enable trap