Printronix L5035 - Manual (Page 72)

Chapter 3 Printer Configuration
72
Horizontal Image Shift
Horizontal Image Shift specifies the amount to shift an image to the
right for precise positioning on the page. The actual width of the
image is not affected. The allowable range is -1.0 to 1.0 inches, in
1/100 inch increments. The default is 0.0 inches.
Vertical Image Shift
Vertical Image Shift specifies the amount to shift an image down for
precise positioning on the page. The actual height of the image is
not affected. The allowable range is -1.0 to 1.0 inches, in 1/100 inch
increments. The default is 0.0 inches.
Toner
The Toner option sets the frequency interval for dispensing toner.
The higher the number selected, the less frequently toner is
dispensed. The allowable range is from 1 to 254. The default is 3.
Reprint on Fault
Reprint on Fault enables (default) or disables automatic reprinting
after a fault condition occurs. If Confirm is selected, the printer
returns a message asking if you want to reprint.
Paper Type
Paper Type allows you to set the printer for either standard or
synthetic paper. The default is Standard; use this setting for most
types of media. Use the Synthetic setting for special types of media
such as plastic cards.
Burst on Eject
Burst on Eject allows you to use roll-feed paper that cannot be cut
(separated) or parked (backed out of the print engine).
• With fanfold paper, whenever you change the page size or
press the PAGE EJECT key, the printer automatically
separates the currently loaded paper at the perforation, and
backs the unprinted paper out of the engine.