Printronix L5035 - Manual (Page 57)

Factory Settings
57
Factory Settings
The configuration defaults set at the factory are listed below. These
values are available for loading at any time, and are maintained in
the printer until a new configuration is loaded.
Table 1. Factory and Configuration Parameters
Menu Item Default Value
Paper Control
Image Width 14.6 inches
Form Length 11.0 inches
Paper Length Auto. Select
Paper Selection Fanfold
Cut Sheet Output Face Down
Fanfold Output Into Stacker
Horizontal Image Shift 0/100 inches
Vertical Image Shift 0/100 inches
Toner 3
Reprint on Fault Enable
Paper Type Standard
Burst on Eject Enable
Cut Sheet Options
Tray Linking Disable
Variable Upper Tray Width Disable
Variable Lower Tray Width Disable
Variable Lower Tray Length Enable
No Back Feed Disable