Kodak 500 - Manual (Page 26)

A-61628 December 2011 3-13
4. Enter the device’s password.
NOTES:
• This field can be left blank. Leave this field blank if the password
has not been changed.
• This field will be grayed out and not needed if the password has
not been changed.
5. Enter the name of the group (or location). For example, the Scan
Station may be located in the main branch of a corporation.
6. Enter any additional information that is important to you in the
Comment field. For example, you can enter the name of the
department where the Scan Station is located.
7. Click Add. The Scanner name and information will be added to the
listing on the KSS500 - Scanner Admin main screen.
NOTES:
• If the Scan Station is not found or if you are adding a Scan
Station that will be installed on the network at a later time, the
message, There was an error communicating with the device,
would you like to Add it anyway? will be displayed. Click Yes
to add the Scan Station.
• If an incorrect IP address is entered, you may have to delete the
Scan Station information from the KSS500 - Scanner Admin main
screen and add it again with the correct information.
8. Follow Steps 1 - 7 to add additional Scan Stations to this group.