Kodak 500 - Manual (Page 124)

A-61628 December 2011 6-7
Uploading firmware
1. Select the Scan Station(s) you want to send new firmware to.
NOTE: To select more than one Scan Station, use the Ctrl or Shift
key. and click the mouse button. The selected Scan
Stations will be highlighted.
2. Select Scanner>Configuration>Firmware Upload. The Open
dialog box will be displayed.
3. Select the file that you want to upload and click Open.
NOTES:
• Only a KSS500UPDATE.EXE file can be uploaded to the Scan
Station.
• The message, Uploading, Please wait will be displayed while
the file is being uploaded.
• If the Scan Station firmware and the KSS500UPDATE firmware
are at the same revision level, no action will be taken.
• You can “roll-back” to an older version or update to a newer
version of the Scan Station firmware. If an older version of the
KSS500UDPATE file is uploaded, the Scan Station will be rolled
back to use the older version of the firmware. If a newer version is
uploaded, the Scan Station will be updated with this newer
firmware.
• You can obtain update packages from the Kodak website or from
your Kodak service representative. Update packages will always
be a file called KSS500UPDATE.EXE file.
• If the following message is displayed during the update, An
unexpected error occurred while installing the software
update. We will attempt to restore the previous version.
Please re-run the software update procedure after the
system reboots, the firmware update failed and your system
could be in mixed version state. Reapply the firmware update
after the system reboots.