Kodak 500 - Manual (Page 15)

3-2 A-61628 December 2011
Setup Wizard When the Scan Station 500 is turned on for the first time, the setup
wizard automatically starts which provides a step-by-step procedure
allowing you to select configuration options (i.e., time, date, etc.) when
connecting to the network.
Other configuration options are also required for Scan Station setup
(i.e., email and fax configurations, etc.); however, these options are
setup using the KSS500 - Scanner Administration application.
Procedures regarding these additional settings are explained in more
detail later in this chapter.
NOTES:
• The procedures that follow are only for the first time you turn on your
Scan Station.
• For detailed information regarding any of the following settings, see
the section entitled, “Configuring your Scan Station” later in this
chapter.
• If Run the wizard at next boot-up is enabled, the wizard will start at
the next power up.
Upon startup the Language screen will be displayed.
1. Select the language that you want the Scan Station user interface to
be display in, then click Done. The following screen will be
displayed.