Kyocera copier - Manual (Page 208)

Shortcuts 12-5
Shortcuts
Transparency Interleave
(p. 9-15)
1 First, load the same size copy paper as the transparencies in any regular tray.
2 Insert one transparency sheet at a time into the Multi-sheet bypass tray.
3 Touch
APPLI. to display the Application selection screen.
4 Touch Transparency Interleave to display the Transparency interleave screen.
5 Touch Blank Sheet Interleaving or Copy Sheet Interleaving , unless your choice is
already highlighted.
6 Touch OK to return to the Application selection screen.
7 Make additional selections.
8 Touch
OK to return to the Basic screen with the required print quantity of [1]
automatically selected.
9 Position the original face up on the RADF (document feeder) tray or face down on
the platen glass.
10 Press [ START ]. When copying is completed, press [ AUTO RESET ] to reset the
machine.
Image Insert
(p. 9-17)
1 In preparation, note the page No. locations of the images you will be scanning from
the platen glass.
2 Touch APPLI. to display the Application selection screen.
3 Touch Image Insert to display the Image insertion No. setting screen.
4 Enter up to 30 page No. locations, touching SET after each entry.
5 When all page No. locations are entered, touch OK to restore the Application
selection screen.
6 Make additional copying selections, or touch OK to return to the Basic screen. The
Store mode is automatically selected.
7 To start scanning, position the regular originals face up on the document feeder tray,
then press [ START ].
8 After the originals on the RADF (document feeder) tray are scanned, enter the print
quantity amount for the job.
9 Next, position one original at a time on the platen glass in ascending order of
pagination, i.e., 1~n.
The platen glass originals can be paste ups, graphs, photos, newspaper articles, or
any non-standard document.
10 In turn, press [ START ] to scan each original from the platen glass.
11 Touch STORE to exit the Store mode.
12 Press [ START ] to combine the non-standard images scanned from the platen glass
with the regular images scanned from the RADF (document feeder). When copying
is completed, press [
AUTO RESET ] to reset machine.