Kyocera copier - Manual (Page 124)

Output Modes 7-19
Output Modes
Manual Stapling (continued)
CAUTION
When the Booklet tray capacity is exceeded, the finisher will cease operating. To avoid such trouble,
select an appropriate print quantity from the specifications on p. 7-12.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
MANUAL OPERATION
Staple Mode
Selection button Staple Start/Stop button
1 Place a set of paper to be stapled into the cover sheet feeder, then align the guide
plate. The indicator light of Staple Start/Stop button will turn green.
NOTE: Refer to the specifications on previous page for available paper size in each mode.
2 Press Staple Mode Selection button to select the desired staple mode.
3 Press Staple Start/Stop button.
Stapled sheets will be delivered to the appropriate tray according to the selected
staple mode.
NOTE: If you want to stop the manual stapling operation, press the Staple Start/Stop button again. The
finisher will cease operating. When using Stapling & Folding mode, the unfinished set will be left in
the stacker unit inside the finisher.