Kyocera copier - Manual (Page 100)

6-38 Basic Operations
Basic Operations
Interrupt Mode
Use the Interrupt mode to interrupt copying in progress to perform a simple job. When
interrupt copying is completed, the settings for the initial job restore automatically and
the Basic Screen displays. Press the [
INTERRUPT ] key when the copier is in the
following conditions:
• Printing continuously the image stored in Store mode
• Scanning the originals in Store mode
• Scanning the originals in Store mode while printing in Reserve mode
If desired, key operator can change the timing to stop current machine operation for
interrupt copying. Note that the compatible copying conditions vary according to the
timing selected. See p. 13-40 ~ p. 13-45.
❒ Incompatible Basic Copying Conditions: Reserve
❒ Incompatible Special Original: None
❒ Incompatible Applications: None
1 To stop the current copying job, press [ INTERRUPT ]. For particular jobs in progress,
copying will cease only after certain phases of the immediate operation are completed,
as indicated by LED conditions described below.
• Collectively printing image stored in memory
The [ INTERRUPT ] LED blinks until one set of the current job is printed. Then the LED
remains steady for the temporary job performed in Interrupt mode.
• Scanning originals into memory
The [ INTERRUPT ] LED blinks until scanning is completed for all originals placed in
the document feeder. Then, the LED remains steady for the temporary job
performed in Interrupt mode.
• Scanning originals into memory while printing in Reserve mode (see Note 1)
The [ INTERRUPT ] LED blinks until the copier completes the current printing job, scans
all originals placed on the document feeder, and prints one set of the Reserved job.
The LED remains steady for the temporary job performed in Interrupt mode.
All JOB indicators on the Basic Screen will change to INTERRUPT .
Basic Screen Control Panel
INTERRUPT
PROOF COPY
STOP
START