Kyocera copier - Manual (Page 166)

Applications 9-23
Applications
Non-Image Area Erase
The Non-image area erase mode is used to copy non standard or special originals, such
as books, magazines, paste-ups, graphs, thin or thick materials, etc. from the platen
glass. The exposed glass area outside the borders of the original will not be copied.
This mode helps to preserve the condition of originals; improves copy quality, and
eliminates unnecessary toner consumption. Keep the document cover open throughout
the procedure.
The Non-image area erase has two modes; namely, Rectangular erase mode and
Oblique erase mode. The copier is initially set to Rectangular erase mode. Contact your
service representative if you desire the Oblique erase mode.
❒ Copy mode: 1-1 mode only (when using Store mode, 1-2 mode can be selected.)
❒ Use the platen glass only.
❒ Original size: 11"x17" ~ 10mm x 10mm
❒ Image cutoff width: leading end 5mm, trailing end 4mm, top and bottom 2mm.
❒ Incompatible Basic Copying Conditions: Using RADF, APS, AMS, Rotation, 2-2, 2-1, Rotation
Sort, Rotation Group, Folding, Stapling & Folding
❒ Incompatible Special Originals: Mixed Original, Z-Folded Original, SDF
❒ Incompatible Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, Image
Insert, Book Copy in RADF Store mode, Reverse Image, All-Image Area, Reduce & Shift in
Image Shift
NOTE: The Non-image area erase function may not operate properly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representative about an appropriate
place for installation.
Oblique erase mode Rectangular erase mode