Kenwood XV-2020 - Manual (Page 85)

85
Using the XV-2020 Effects
Using the XV-2020
Effects
13: SPACE-D
This is a multiple chorus that applies two-phase modulation in
stereo. It creates no audible modulation, yet produces a transparent
chorus effect.
fig.02-013m
14: STEREO CHORUS
This is a stereo chorus. A filter is provided so that you can adjust the
timbre of the chorused sound.
fig.02-014m
15: STEREO FLANGER
This is a stereo flanger. (The LFO has the same phase for left and
right.) It produces a metallic resonance that rises and falls somewhat
like a jet airplane taking off or landing. A filter is provided so that
you can adjust the timbre of the flanged sound.
fig.02-015m
16: STEP FLANGER
This is a flanger in which the flanger pitch changes in steps. The
speed at which the pitch changes can also be specified in terms of a
note value based on a specified tempo.
fig.02-016m
Parameter Value Description
Cho Rate # 0.05-10.00 Hz Frequency of modulation
Cho Depth 0-127 Depth of modulation
Cho Phase 0-180 deg Spatial spread of the sound
Pre Delay 0.0-100.0 ms Adjusts the time until the chorus
sound is heard.
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Balance # D100:0W-
D0:100W Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0-127 Output level
Parameter Value Description
Rate # 0.05-10.00 Hz Frequency of modulation
Depth 0-127 Depth of modulation
Phase 0-180 deg Spatial spread of the sound
Pre Delay 0.0-100.0 ms Adjusts the time until the chorus
sound is heard.
Filter Type OFF, LPF,
HPF Type of filter
OFF: no filter is used
LPF: cuts the frequency range above the
Cutoff Freq
HPF: cuts the frequency range below the
Cutoff Freq
Cutoff Freq 200-8000 Hz Basic frequency of the filter
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Balance # D100:0W-
D0:100W Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0-127 Output level
L in
R in
Space D
Space D
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
L in
R in
Chorus
Chorus
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
Parameter Value Description
Rate # 0.05-10.00 Hz Frequency of modulation
Depth 0-127 Depth of modulation
Feedback # -98-+98% Adjusts the amount of the flanger sound
that’s fed back into the effect. Negative (-)
settings invert the phase.
Phase 0-180 deg Spatial spread of the sound
Pre Delay 0.0-100.0 ms Adjusts the time until the flanger sound is
heard.
Filter Type OFF, LPF, HPF Type of filter
OFF: no filter is used
LPF: cuts the frequency range above the
Cutoff Freq
HPF: cuts the frequency range below the
Cutoff Freq
Cutoff Freq 200-8000 Hz Basic frequency of the filter
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Balance D100:0W-
D0:100W Volume balance between the direct sound
(D) and the flanger sound (W)
Level 0-127 Output level
Parameter Value Description
Rate 0.05-10.00 Hz Frequency of modulation
Depth 0–127 Depth of modulation
Feedback # -98-+98 % Adjusts the amount of the flanger
sound that’s fed back into the effect.
Negative (-) settings invert the phase.
Phase 0-180 deg Spatial spread of the sound
Pre Delay 0.0-100.0 ms Adjusts the time until the flanger
sound is heard.
Step Rate # 0.10-20.00 Hz, note
*1 Rate (period) of pitch change
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Balance D100:0W-D0:100W Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0-127 Output level
R in R out
L in L out
Flanger
Feedback
Feedback
Flanger
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger