Kenwood XV-2020 - Manual (Page 38)

38
Playing Sounds
Choosing a Performance
The collected assignment of Patches or Rhythm Sets to the XV-2020’s sixteen Parts is
referred to as a
“Performance.”
fig.00-10e
Selecting Performances and Parts
1.
Press [VALUE], so the PERFORM indicator lights up.
* Only the PERFORM indicator should be lit.
2.
Turn [VALUE] to choose the Performance.
3.
Rotate [PART] to change the Part for the currently selected
Performance.
* Rotating [PART] while in Performance Play mode switches you to Performance Part Play mode.
Assigning a New Patch to a Part
Here’s how to change the Patch assigned to a Part in a Performance.
1.
Press [VALUE] a number of times until both the PERFORM and the
PATCH indicators light up.
2.
Turn [PART] to choose the part.
3.
Rotate [CATEGORY/BANK] to switch the bank, then rotate [VALUE] to
select the Patch.
SYN/PAD HLD HARD LEAD Hard Synth Lead
SLD SOFT LEAD Soft Synth Lead
TEK TECHNO SYNTH Techno Synth
PLS PULSATING Pulsating Synth
FX SYNTH FX Synth FX (Noise, etc.)
SYN OTHER SYNTH Poly Synth
BPD BRIGHT PAD Bright Pad Synth
SPD SOFT PAD Soft Pad Synth
VOX VOX Vox, Choir
ETHNIC PLK PLUCKED Plucked (Harp, etc.)
ETH ETHNIC Other Ethnic
FRT FRETTED Fretted Inst (Mandolin, etc.)
RHYTHM&SFX PRC PERCUSSION Percussion
SFX SOUND FX Sound FX
BTS BEAT&GROOVE Beat and Groove
DRM DRUMS Drum Set
CMB COMBINATION Other Patches which use Split and Layer
Category
Group XV Editor
Display Category Contents
Part 10
Performance
Part 1
Rhythm set
Patch
Part 16 Patch
Performances can only be
selected when the
[CATEGORY/BANK]
knob is pointed at either
USER, PST-A, or PST-B. So,
if you're unable to switch
Performances, check the
position of the knob.