Kenwood XV-2020 - Manual (Page 26)

26
For Those Using a Computer
fig.3-2_35
5.
If a message like the following is displayed,
click
[Continue] .
The other currently running applications will
exit, and installation will continue.
6.
A dialog box will indicate Installation completed .
Click [Restart] to restart your Macintosh.
7.
Use the USB cable to connect the XV-2020 to your computer.
1. With the XV-2020’s power switch turned off, connect it to the AC adaptor.
2. Plug the AC adaptor into an AC power outlet.
3. Use the USB cable to connect the XV-2020 to your computer.
8.
Set the XV-2020’s power switch to the ON position.
OMS settings
1.
Use the USB cable to connect the XV-2020 and your Macintosh.
fig.USB-02.e
fig.oms-05_50
2.
Double-click the “OMS Setup” icon.
fig.oms-06.e_70
3.
If the “Apple Talk” dialog box appears,
click [Turn It Off] .
Then, in the dialog box that appears next,
click
[OK] .
fig.oms-07.e_75
4.
The “Create a New Studio setup” dialog
box appears.
Click [OK] .
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
USB cable
Computer
XV-2020
To prevent malfunction
and/or damage to speakers
or other devices, always
turn down the volume, and
turn off the power on all
devices before making any
connections.
If you are using the XV-
2020 with a sequencer, do
not disconnect the MIDI
cable connected to the XV-
2020 while a song is
playing back.
If the “Create a New
Studio setup” dialog box
does not appear, click [New
Studio setup] in the [File]
menu.