Kenwood XV-2020 - Manual (Page 117)

117
List of Parameters That Can Be
Affected Using the XV-2020
List of Parameters That Can Be
Affected Using the XV-2020
Switching modes
SYSTEM parameter
PATCH parameter
PERFORMANCE parameter
Mode Page Procedure
Patch Play Mode p. 35 Press [VALUE] to make the PATCH indicator lights up.
Performance Part Play Mode p. 38 Press [VALUE] to make the PATCH (RHYTHM) and PERFORM indicators light.
Performance Play Mode p. 38 Press [VALUE] to make the PERFORM indicator lights up.
Rhythm Play Mode p. 35 Press [VALUE] to make the RHYTHM indicator lights up.
GM Play Mode p. 96 Press [VALUE] to make the GM indicator lights up.
Patch Edit Mode p. 44 In Patch Play Mode, while holding down [VOLUME], press [VALUE].
Performance Edit Mode p. 70 In Performance Play Mode and Performance Part Play Mode,
while holding down [VOLUME], press [VALUE].
Rhythm Edit Mode p. 62 In Rhythm Play Mode, while holding down [VOLUME], press [VALUE].
GM Edit Mode p. 96 In GM Play Mode, while holding down [VOLUME], press [VALUE].
Parameter Page Procedure
Master Tune p. 94 While holding down [VOLUME], press [VALUE].
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
Turn [VALUE] to select the desired setting. ->
Pressing [VALUE] to set values (Write). ->
While holding down [VOLUME], press [VALUE].
* Changes made to the MIDI-USB Thru and USB Descriptor settings are not reflected until
the power is turned off, then on again.
Performance Control Channel p. 94
MIDI-USB thru p. 95
USB Descriptor p. 95
Parameter Page Procedure
LEVEL p. 46 Press [VALUE] to make the PATCH indicator lights up. ->
While holding down [VOLUME], press [VALUE]. ->
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
Turn [VALUE] to select the desired setting. ->
While holding down [VOLUME], press [VALUE].
PAN p. 46
COARSE TUNE p. 46
FINE TUNE p. 46
OUTPUT ASSIGN p. 46
CUTOFF OFFSET p. 47
RESONANCE OFFSET p. 47
ATTACK TIME OFFSET p. 47
RELEASE TIME OFFSET p. 47
OCTAVE SHIFT p. 46
ANALOG FEEL p. 47
Parameter Page Procedure
PART LEVEL p. 72 Press [VALUE] to make the PERFORM indicator lights up. ->
While holding down [VOLUME], press [VALUE]. ->
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
Turn [VALUE] to select the desired setting. ->
While holding down [VOLUME], press [VALUE].
PART PAN p. 72
PART COARSE TUNE p. 72
PART FINE TUNE p. 72
PART OUTPUT ASSIGN p. 73
PART VOICE RESERVE p. 73
PART REVERB SEND LEVEL p. 79
PART CHORUS SEND LEVEL p. 73
PART DRY SEND LEVEL p. 73
PART TYPE (PATCH/RHYTHM) p. 72
PERFORMANCE MFX SOURCE p. 80