Kenwood XV-2020 - Manual (Page 15)

15
For Those Using a Computer
For Those Using a
Computer
fig.2-3_40
9.
In the dialog box that appears, input the
following into the
“Open” field, and click
[OK] .
E:\Win2000\XV-2020\SETUPINF.EXE
* The drive name “E:” may be different for
your system. Specify the drive name of your
CD-ROM drive.
fig.2-4_30
10.
The SetupInf dialog box will appear.
You are now ready to install the driver.
* Do not click [OK] at this time.
11.
Connect the XV-2020.
1. With the XV-2020’s power switch
turned off, connect it to the AC
adaptor.
2. Plug the AC adaptor into an AC power
outlet.
3. Use the USB cable to connect the XV-
2020 to your computer.
12.
Set the XV-2020’s power switch to the ON position.
Near the task bar, your computer will indicate “Found New Hardware.” Please
wait.
fig.2-6_30
13.
The Found New Hardware wizard will
appear.
Make sure that the screen indicates
“ROLAND XV-2020,” select “Install from
a list or specific location (Advanced),”
and click [Next] .
fig.2-7_30
14.
The screen will indicate “Please choose
your search and installation options.”
Select “Don’t search. I will choose the
driver to install,” and click [Next] .
If a message of “The driver
is already installed”
appears, you can connect
the XV-2020 to your
computer and use it.
This unit is equipped with
protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.