Sharp UP-600 - Manual (Page 33)

33
Price change function (for UPCs)
You can use this function when you need to change the unit price or associated department of a UPC item
in REG/MGR mode.
There are two methods for the price change function:
1. Price change mode
You can change the preset price and/or the associated department of a UPC item without entering PGM
mode.
2. Changing the price during a transaction
When a wrong UPC price and/or associated department is found during a transaction, you can correct
them at the time of transaction. With the entry of a new price and/or associated department, the preset
price and/or associated department is automatically changed to the new price and/or associated
department.
NOTE
For the Non-PLU type price embedded UPC-A codes and press codes, the prices in the codes
have the priority over the preset prices. So, for these codes, a changed price is valid only when
the price change is executed.
NOTE
• When an undefined code is entered in the price change mode, the register goes to an error
status.
• When you press the PRICE
CHANGE
key during a transaction, the UPC entry is overridden upon the 1st
depression of the
PRICE
CHANGE
key, then you are allowed to enter a correct price and/or associated
department.
• When an associated department is changed, the item label for the department will also be
changed automatically to the item label of new associated department.
• For the repeat entry, use the
REPEAT
key.
UPC code
Scan UPC code
“PRICE CHANGE” is displayed.
UPC code
Dept code
Department key
Scan UPC code
To cancel
To enter 0
Unit price
To change the unit price only
To change the associated dept.
using the dept. code entry key
To change the associated dept.
directly by depressing the
corresponding key
Changing price during a transaction
PRICE
CHANGE
PRICE
CHANGE
PRICE
CHANGE
Price change mode
“ENTER AMOUNT” window is opened.
DEPT
#
CA/AT
ENTER
or
CANCEL
CA/AT
ENTER
or
or
PLU/UPC
PLU/UPC