Sharp UP-600 - Manual (Page 220)

220
Installing the paper roll
Installing the receipt paper roll
1. Open the printer cover. Set the paper roll correctly as
illustrated and drop it into the printer.
2. Press the receipt paper release lever down and insert
the paper end into the paper chute of the printer. Pull
the paper end that has come out of the printer, holding
down the lever.
3. Advance the paper by a required length by pressing the
receipt paper feed key.
Installing the journal paper roll
1. Open the printer cover. Set the paper roll correctly and
drop it into the printer.
2. Press the journal paper release lever down, insert the
paper end that has come out of the printer into the slit in
the paper take-up spool, wind it two or three turns
around the spool shaft, and set the spool on the
bearing.
NOTE
Make sure the ink ribbon cassette has been
mounted on the printer when installing the
receipt paper roll or the journal paper roll.
Wind two or
three turns.
Slit