Sharp UP-600 - Manual (Page 18)

18
Prior to Entries
Preparations for Entries
Receipt and journal paper rolls
If the receipt and journal paper rolls are not set in the machine or the existing rolls are low in supply, install
new ones according to section “Installing and Removing the Paper Roll” under “Operator Maintenance.”
Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt function. To disable
receipt printing, press the
MISC
FUNC
key and select RCP S.W. from the menu and turn the receipt OFF by press
the • key. When the function is in the OFF status, the receipt off indicator “R” is highlighted.
NOTE
Your register will print reports regardless of the receipt state. This means that the receipt roll
should be installed even when the receipt state is “OFF”.
Error Warning
In the following examples, your POS terminal will go into an error state accompanied with a warning beep
and the error message on the display. Clear the error state by pressing the
CL
key and take the proper
action to remedy the problem.
• When you exceed a 32-digit number (entry limit overflow):
Cancel the entry and re-enter a correct number.
• When you make an error in key operation:
Clear the error and try the entry again.
• When you make an entry beyond a programmed amount entry limit:
Check to see if the entered amount is correct. If it is correct, it may be possible to enter it in the
MGR mode. Please contact your manager.
• When an including-tax subtotal exceeds eight digits:
Clear the error display by pressing the
CL
key and press a media key to finalize the transaction.
Sample Receipt
The print format will vary depending on the printer you use.
4
REG MODE
Machine no.
Server name/server code
Date
Consecutive no.
Item entry
Time
Cash amount tendered
Change due
Sales total