SMC Networks TigerStack 100 1000BASE-X - Manual (Page 48)

U
SING THE
S
YSTEM
C
ONFIGURATION
P
ROGRAM
2-30
Configuring Port Parameters
Use the Port Configuration menus to set or display communication
parameters for any port or module in the stack.
Port Configuration : Unit 1 Port 1 - 12
==================
Flow Control on all ports : [Enable] [Disable]
Port Type Admin Flow Control Speed and Duplex
--------------------------------------------------------
1 100FX ENABLED DISABLED 100_FULL
2 100FX ENABLED DISABLED 100_FULL
3 100FX ENABLED DISABLED 100_FULL
4 100FX ENABLED DISABLED 100_FULL
5 100FX ENABLED DISABLED 100_FULL
6 100FX ENABLED DISABLED 100_FULL
7 100FX ENABLED DISABLED 100_FULL
8 100FX ENABLED DISABLED 100_FULL
9 100FX ENABLED DISABLED 100_FULL
10 100FX ENABLED DISABLED 100_FULL
11 100FX ENABLED DISABLED 100_FULL
12 100FX ENABLED DISABLED 100_FULL
Use or arrows keys to move. to scroll options.
Parameter Default Description
Flow Control
on all ports
Disabled See “Flow Control” in this table.
Type Shows port type as:
100FX :
100BASE-FX
1000SX : 1000BASE-SX
1000LX : 1000BASE-LX
1000T : 1000BASE-T
Admin Enabled Allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then re-enable it after
the problem has been resolved. You may also disable
a port for security reasons.