SMC Networks TigerStack 100 1000BASE-X - Manual (Page 31)

M
ANAGEMENT
S
ETUP
M
ENU
2-13
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the
switch’s IP parameters. The screen shown below is described in the
following table.
Network Configuration : IP Configuration
========================================
Interface Type : Ethernet
IP Address : 10.1.113.29
Subnet Mask : 255.255.0.0
Gateway IP :
IP State : USER-CONFIG
Use or arrow keys to move, other keys to make changes.
Parameter Description
Interface Type Indicates IP over Ethernet.
IP Address IP address of the stack you are managing. The system
supports SNMP over UDP/IP transport protocol. In this
environment, all systems on the Internet, such as network
interconnection devices and any PC accessing the agent
module (or running EliteView) must have an IP address.
Valid IP addresses consist of four numbers, 0 to 256,
separated by periods. Anything outside of this format will
not be accepted by the configuration program.
Subnet Mask Subnet mask of the switch you have selected. This mask
identifies the host address bits used for routing to specific
subnets.