Appendix – Sanyo PJLINK PLC-WM4500 User Manual
Page 90
90
Appendix
The command is sent from PC to the projector with the
format below;
'CR' [Command] 'CR'
Command: one character (refer to the command table
below.
The projector decodes the command and returns the
'Character string' with the format below;
Format
The tables on page 89 and 90 show the typical command lists for controlling the projector. Please consult your local dealer
for further information of other commands.
Command
Function
Projector
Return
Projector status
CR0
Status Read
00
Power On
80
Stand-by mode
40
Countdown
20
Cooling down
10
Power Malfunction
28
Cooling down at the temperature anomaly
24
Cooling down at Power Management mode
04
Power Management mode after Cooling down
21
Cooling down after the projector is turned off when the lamps
are out.
81
Stand-by mode after Cooling down when the lamps are out.
88
Stand-by mode after Cooling down at the temperature
anomaly.
CR6
Temperature Read
S1 S2 S3
S1 = Temperature at Sensor 1 (˚C)
S2 = Temperature at Sensor 2 (˚C)
S3 = Temperature at Sensor 3 (˚C)
(ex.) S1 = 12.3˚C��� S2 = 23.4˚C��� S3 = 34.5˚C
��� S2 = 23.4˚C��� S3 = 34.5˚C
S2 = 23.4˚C��� S3 = 34.5˚C
--> The projector displays “12.3 23.4 34.5”
( For each sensor, two digit and the tenth place numbers are
displayed with a space between each temperature.)
?
Communication failure
Status Read Command