Sanyo PJLINK PLC-WM4500 - Manual (Page 34)

4
INPUT MENU
When your computer is connected to the INPUT 1 (ANALOG)
terminal, select RGB (PC analog).
RGB(PC analog)
P Note:
Input source changes if the INPUT 1 button on the remote control is
pressed.
When connecting the computer output [5 BNC Type (Green, Blue,
Red, Horiz. Sync, and Vert. Sync.)] from the computer to G, B, R,
H/HV and V jacks:
Input Selection
When your computer is connected to the INPUT 2 (5 BNC
INPUT JACKS) terminal, select RGB.
RGB
1
Press the MENU button to display the On-Screen Menu. Use
the Point
pq buttons to select Input and then press the
Point u or the SELECT button.
Use the Point pq buttons to select the desired input and
then press the Point u button to access the submenu items.
Use the Point pq buttons to select the desired source and
then press the SELECT button.
INPUT MENU
INPUT 1 MENU
Computer Input Source Selection
WHEN SELECTING INPUT 1
(COMPUTER INPUT TERMINALS )
WHEN SELECTING INPUT (5 BNC INPUT jACKS )
Menu Operation
Input 1
RGB(PC analog)
RGB(Scart)
HDMI
Y,Pb/Cb,Pr/Cr