Sanyo PJLINK PLC-WM4500 - Manual (Page 27)

7
The following lens operation can be made with the Lens button on
the side control.
Press the LENS button to enter each lens operation mode. The
selected adjustment display appears on the screen.
Display Lens shift on the screen. Use the Point pqt u
buttons to position the screen to the desired point without having
picture distortion.
The screen can be moved up or down to 60 percent, or sideways
up to 10 percent from the central axis of the lens shift.
Press and hold the LENS button on the side control or the LENS
SHIFT button on the remote control for 5 seconds or more to
return the lens to the center position, after that the four white
arrows on the screen turn to red.
Lens Shift Adjustment
P Note:
• The arrow disappears at the maximum lens shift in each
direction.
• The arrow turns red when the lens shift comes to the
center position of the screen.
Display Zoom on the screen. Use the Point pq buttons to
zoom in and out the image.
Zoom Adjustment
Display Focus on the screen. Use the Point pq buttons to
adjust focus of the image.
Focus Adjustment
Side Control
Lens Operation
Zoom
Zoom " Focus " Lens Shift " • • • • •
Basic Operation
INFO . button
LENS button
POINT buttons
Focus
Lens shift
Operating with Projector Control
Ф
Ф
Ф

INFO . button
Information display can be used to confirm the current operating
condition of the projector and the signal being projected through
the projector.
Press the INFO. button on the remote control to display the
information window on the screen. To hide the information
window, press the INFO. button again or press the MENU button.
The information window can also be selected from the
menu.
Information Menu
P Note:
• The H-sync freq. and V-sync freq. values described in the
figure may be different from the actual values.
• SERIAL NO. is used to service the projector.